660
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_gen_op_overview_setup_call.fm
How Do I Set Up a Call?
How Do I Set Up a Call?
• “How Do I Set Up an IS-2000 Call?” on page 660
• “How Do I Set Up an IS-95 Call?” on page 662
How Do I Set Up an IS-2000 Call?
The Call Parms keys and Call Control keys provide access to the parameters needed to set up a call.
1. Press the
CALL SETUP key.
2. Press the Operating Mode (
F1) key and set the operating mode to Active Cell.
3. Press the System Type (
F2) key and select IS-2000.
4. Press the Cell Band (
F8) key and select the band in which you would like to bring up the call.
5. Press the Radio Config (
F11) key and select the radio configuration in which you would like to bring up
the call.
6. Press the FCH Service Option Setup (F12) key and set the service option for the radio configurations
you plan on testing.
NOTE SO55 (Service Option 55) is not supported by some mobile stations. If your mobile station does
not support SO55 calls cannot be connected, and you will need to select one of the other loopback
or echo service options.
7. Check the rest of the Call Parms settings by pressing the
More key to display the 2 of 3 and 3 of 3 menus.
1
7
4
5
2
1
3
6
1
To Next Page
Loading...
Need help?
General
