653
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_common.fm
IEEE 488.2 Common Commands
*OPT?
The *OPT?, option identification query, is defined in “IEEE Std 488.2-1992”, 10.20. Each option will have a
unique name, that name will be retuned with the query.
*RST
The *RST, full preset command, is defined in “IEEE Std 488.2-1992”, 10.32. *RST is the recommended
command when performing a full preset on the test set. A *RST restores the majority of settings to their
default values.
• *RST sets trigger arm to single
• PRESet2 sets trigger arm to continuous
*SRE
The *SRE, service request enable command, is defined in “IEEE Std 488.2-1992”, 10.34. The parameter range
for this command is 0 through 255.
*SRE?
The *SRE?, service request enable query, is defined in “IEEE Std 488.2-1992”, 10.35. Values returned by this
query range from 0 through 255.
*STB?
The *STB?, read status byte query, is defined in “IEEE Std 488.2-1992”, 10.36. Values returned by this query
range from 0 through 255.
*WAI
The *WAI, wait-to-continue command, is defined in “IEEE Std 488.2-1992”, 10.39. The *WAI command
prevents the test set from executing any further commands or queries until all pending operation flags are
false. The *WAI common command is not recommended for use as an overlapped command.
See also
“Obtaining Identification Information (*IDN)”
“Preset Descriptions”
To Next Page
Loading...
