Agilent Technologies 8960 Series

109
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_prog_getting_started_step3_ac.fm
Step 3: Set Measurement Parameters
Step 3: Set Measurement Parameters
This step gives an example of how you can configure measurement parameters. For more information about
measurement parameters, refer to the Introduction to Programming the Agilent Technologies 8960, Step 3.
10 OUTPUT Testset;”SET:CONT OFF”
20 OUTPUT Testset;”SET:WQU:TIM:STIM 10”
30 OUTPUT Testset;”SET:DAP:TIM:STIM 5”
40 OUTPUT Testset;”SET:CPOW:TIM:STIM 5”
50 !