340
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_call_operating.fm
CALL[:CELL]:OPERating
CALL[:CELL]:OPERating
“Diagram Conventions” on page 248
CALL[:CELL]:OPERating:MODE
Function Sets/queries the operating mode of the base station emulator. If a call is in progress during a
change in operating mode it will be dropped.
CALL is the default operating mode. In CALL mode (also called active cell mode), signaling
between the mobile station and the base station emulator is used for call origination, handoffs,
and other operations that simulate in-service mobile interaction. When CALL is selected, closed
loop power control will be automatically set to its active mode. See
“CALL[:CELL]:CLPControl:REVerse:MODE” for closed loop power control commands.
D2KTest mode commands the test set to transmit a forward CDMA channel with no call
processing capability. In this mode, a mobile station that complies with IS-2000 test mode will
camp on to the forward channel. The test set will continually send an F-FCH on the user entered
Walsh code, which the mobile station can use to make FER measurements. The mobile station
must begin transmitting the R-FCH before reverse link measurements can be made.
Setting Range: AVCTest|CALL|D2KTest|CW
Query Range: AVCT|CALL|D2KT|CW
*RST Setting CALL
Programming Example
OUTPUT 714;"CALL:CELL:OPERATING:MODE D2KTEST" !Selects IS-2000 test mode.
CALL :MODE:OPERating
<sp> AVCTest|CALL|D2KTest|CW
? (returns AVCT|CALL|D2KT|CW)
:CELL
To Next Page
Loading...
Need help?
General
