Agilent Technologies 8960 Series Reference Guide

111
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_prog_getting_started_step5_ac.fm
Step 5: INITiate and FETCh Measurements
Step 5: INITiate and FETCh Measurements
INITiate measurements and FETCh results
Below are examples of performing tests and retrieving their results. Refer to the Introduction to 8960
Programming for more information about the different measurement results that are available and how to
fetch them.
785 !***********************
786 ! WAVEFORM QUALITY TEST*
787 !***********************
788 !
789 !***Specify test parameters for waveform quality test***
790 !
791 Ior=-75
792 Pilot=-7
793 Traffic=-7.4
794 !
796 !***Set up measurement parameters***
797 !
799 OUTPUT Testset;”CALL:POW “;Ior
800 OUTPUT Testset;”CALL:PIL “;Pilot
810 OUTPUT Testset;”CALL:FCH “;Traffic
820 !
830 !***Obtain and display measurement results***
831 !
840 OUTPUT Testset;”SYST:SYNC?”
841 ENTER Testset;Syst_sync$
842 !
843 Wqu_timer=TIMEDATE
850 OUTPUT Testset;”INIT:WQU”
860 LOOP
870 OUTPUT Testset;”INIT:DONE?”
880 ENTER Testset;Meas_done$
890 EXIT IF Meas_done$=”WQU”
900 END LOOP
910 OUTPUT Testset;”FETC:WQU?”
920 ENTER Testset;Integrity,Rho,Freq_error,Time_error,Carr_feed,Phase_err,Mag_err,Evm
921 !
930 !***Print Waveform Quality Results
931 !
932 DISP “Waveform Quality Test complete”
933 PRINT “Waveform Quality Test Results:”
934 !
935 PRINT “ Integrity indicator = “,Integrity
940 Print_results(“Rho = “,Rho,””)
941 Print_results(“Frequency error = “,Freq_error,”Hz”)
942 Print_results(“Time error = “,Time_error,”us”)
943 Print_results(“Carrier feedthrough = “,Carr_feed,”dBc”)
950 Print_results(“Phase error = “,Phase_err,”deg”)
951 Print_results(“Magnitude error = “,Mag_err,”%”)

Agilent Technologies 8960 Series Specifications

General

Brand	Agilent Technologies
Model	8960 Series
Category	Test Equipment
Language	English