Agilent Technologies 8960 Series - Page 518

518
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_setup_cappower.fm
SETup:CAPPower
SETup:CAPPower:CONTinuous
SETup:CAPPower:TIMeout[:STIMe]
SETup:CAPPower:TIMeout:STATe
Function Sets/queries the trigger arm state for the access probe power measurement. The trigger arm
state determines whether the access probe power measurement will be made on the first access
probe in an access probe sequence then stop (0|OFF (single)), or automatically re-arm and make
measurements on each of the following access probes (1|ON (continuous)).
Setting Range: 1|ON|0|OFF
Query Range: 1|0
*RST Setting 0 (off)
Programming Example
OUTPUT 714;"SETUP:CAPPOWER:CONTINUOUS OFF
"
!Sets measurement to single trigger mode.
Function The setting form of this command performs two functions: (1) sets the access probe power
measurement’s timeout (see “Timeouts” ) value, and (2) sets the access probe power
measurement’s timeout STATe to 1 (on).
The query form returns the access probe power measurement’s timeout value.
Setting Range: 0.1 to 999.9 seconds
Resolution: 0.1 second
Query Range: 0.1 to 999.9
*RST Setting 10 seconds, on
Programming Example
OUTPUT 714;"SETUP:CAPPOWER:TIMEOUT:STIME 5 S"
!Sets timeout state to ON and sets the timeout time to 5 seconds.
Function Sets/queries the access probe power measurement’s timeout (see “Timeouts” ) state.
Setting Range: 1|ON|0|OFF
Query Range: 1|0
*RST Setting 0 (off)
Programming Example
OUTPUT 714;"SETUP:CAPPOWER:TIMEOUT:STATE ON"