Agilent Technologies 8960 Series Reference Guide

113
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_prog_getting_started_step5_ac.fm
Step 5: INITiate and FETCh Measurements
1034 Print_results(“FER Errors Count”,Fer_count,”frames”)
1035 Print_results(“Frames Tested”,Frames_tested,””)
1036 PRINT
1037 !
1039 Fer_time=PROUND(TIMEDATE-Fer_timer,-2)
1040 Print_results(“FER Test Time= “,Fer_time,”secs”)
1041 PRINT
1042 !
1043 !***************
1044 !Max Power Test*
1045 !***************
1046 !
1047 !***Set up measurement parameters***
1048 !
1049 Ior=-70
1051 Pilot=-7
1052 Traffic=-7.4
1053 !
1055 OUTPUT Testset;”CALL:POW “;Ior
1056 OUTPUT Testset;”CALL:PIL “;Pilot
1057 OUTPUT Testset;”CALL:FCH “;Traffic
1058 OUTPUT Testset;”CALL:CLPC:REV:MODE UP”
1060 !***Obtain measurement results***
1061 !
1062 WAIT 1!Settling time
1063 Max_timer=TIMEDATE
1064 OUTPUT Testset;”INIT:DAP”
1065 LOOP
1066 OUTPUT Testset;”INIT:DONE?”
1067 ENTER Testset;Meas_done$
1068 EXIT IF Meas_done$=”DAP”
1069 END LOOP
1070 OUTPUT Testset;”FETC:DAP?”
1071 ENTER Testset;Integrity,Avg_power_dbm
1072 !
1073 Avg_power_dbw=Avg_power_dbm-30
1074 !
1075 !***Display measurements if the mobile station did not drop the call***
1076 !
1077 OUTPUT Testset;”CALL:STAT?”
1078 ENTER Testset;Call_status$
1079 IF Call_status$<>”CONN” THEN
1080 PRINT “Mobile station dropped call, invalid results”
1081 END IF
1082 !
1083 !***Print Max Power Test Results
1084 !
1085 DISP “Max Power Test complete”
1086 PRINT “Max Power Test Results:”
1087 !
1088 !
1089 PRINT “ Integrity indicator = “,Integrity
1090 Print_results(“Maximum Power dBm:”,Avg_power_dbm,”dBm”)

Agilent Technologies 8960 Series Specifications

General

Brand	Agilent Technologies
Model	8960 Series
Category	Test Equipment
Language	English