373
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_call_setup_avc.fm
CALL:SETup:AVC
CALL:SETup:AVC[:CHANnel][:SELected]
CALL:SETup:AVC[:CHANnel]:CELLular
CALL:SETup:AVC:SATone[:CCODe]
Function Sets/queries the RF channel number of the analog voice channel.
During active cell operating mode, this setting does not take affect until a call is originated on
the AVC or a handoff occurs to a new AVC. This setting takes effect immediately during AVC Test
operating mode.
Setting Range: 1 through 799, 991 through 1023, 9.91 E+37
Query Range: 1 through 799, 991 through 1023, 9.91 E+37
*RST Setting 300
Programming Example
OUTPUT 714;”CALL:SETUP:AVC:CHANNEL:SELECTED 799” !Set the AVC to channel 799.
Function Sets/queries the RF channel number of the analog voice channel, specifying the cellular band
(800 MHz).
During active cell operating mode, this setting does not take affect until a call is originated on the
AVC or a handoff occurs to a a new AVC. This setting takes effect immediately during AVC Test
operating mode. PCS band analog operation is currently not supported.
Setting Range: 1 through 799, 991 through 1023, 9.91 E+37
Query Range: 1 through 799, 991 through 1023, 9.91 E+37
*RST Setting 300
Programming Example
OUTPUT 714;”CALL:SETUP:AVC:CHANNEL:CELLULAR 799” !Set the AVC to cell band channel 799.
Function Sets/queries the supervisory audio tone’s color code (frequency).
In active cell mode, this command sets/queries the SAT color code (frequency) to be used on the
next handoff.
In test mode, this command sets/queries the current SAT color code (frequency).
Setting Range: SAT1|SAT2|SAT3
SAT1 = 5970 Hz
SAT2 = 6000 Hz
SAT3 = 6030 Hz
Query Range: SAT1|SAT2|SAT3
*RST Setting SAT2
Programming Example
OUTPUT 714;”CALL:SETUP:AVC:SATONE:CCODE SAT1” !Sets the SAT frequency to 5970 Hz.
To Next Page
Loading...
