571
S:\Hp8960\E1962B CDMA 2000\Pi Release\Reference Guide\Chapters\cdma2000_hpib_setup_wquality.fm
SETup:WQUality
SETup:WQUality:TIMeout[:STIMe]
SETup:WQUality:TIMeout:STATe
SETup:WQUality:TIMeout:TIME
Function The setting form of this command performs two functions: (1) sets the waveform quality
measurement’s timeout value, and (2) sets the waveform quality measurement’s timeout STATe
to 1 (on).
The query form returns the waveform quality measurement’s timeout value.
Setting Range: 1 to 999 seconds
Resolution: 1 second
Query Range: 1 to 999
*RST Setting 10 seconds, on
Programming Example
OUTPUT 714;"SETUP:WQUALITY:TIMEOUT:STIME 5S"
!Sets timeout state to ON and sets the timeout time to 5 seconds.
Function Sets/queries the waveform quality measurement’s timeout state.
Setting Range: 1|ON|0|OFF
Query Range: 1|0
*RST Setting 0 (off)
Programming Example
OUTPUT 714;"SETUP:WQUALITY:TIMEOUT:STATE ON"
Function Sets/queries the waveform quality measurement’s timeout setting to be used when the timeout
state is set to ON.
Setting Range: 1 to 999 seconds
Resolution: 1 second
Query Range: 1 to 999
*RST Setting 10 seconds
Programming Example
OUTPUT 714;"SETUP:WQUALITY:TIMEOUT:TIME 5S"
To Next Page
Loading...
