Allied Telesis AT-GS908M - Page 221

AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 221
“RESET SWITCH
STORMDETECTION COUNTER”
on page 251
Clears counters for Storm Detection.
“SET SWITCH LIMITATION” on
page 252
Specifies the limitation of the receiving rate for
Storm Detection.
“SET SWITCH
LOOPDETECTION” on page 253
Specifies actions for Loop Detection.
“SET SWITCH MIRROR” on
page 255
Specifies a port as the mirror port or disable port
mirroring.
“SET SWITCH PORT” on
page 257
Specifies the mirror port, communication mode,
receiving frame type, security mode, or combo
port.
“SET SWITCH
STORMDETECTION” on
page 263
Specifies actions for Storm Detection.
“SET SWITCH TRUNK” on
page 266
Changes the settings of trunk groups.
“SHOW SWITCH” on page 267 Displays information about the switch.
“SHOW SWITCH COUNTER” on
page 268
Displays statistics counters on the switch.
“SHOW SWITCH
LOOPDETECTION” on page 269
Displays information about Loop Detection.
“SHOW SWITCH MIRROR” on
page 271
Displays information about mirroring.
“SHOW SWITCH PORT” on
page 272
Displays information about ports.
“SHOW SWITCH PORT
COUNTER” on page 274
Displays statistics counters on ports.
“SHOW SWITCH
STORMDETECTION” on
page 276
Displays information about Storm Detection.
“SHOW SWITCH TRUNK” on
page 278
Displays information about trunk groups.
Table 31. Switching Commands (Continued)
Command Description