Chapter 27: Port-Based Authentication Commands
506 Section IV: Security and Traffic Control
ENABLE PORTAUTH
Syntax
enable portauth
Parameters
None
Description
Use this command to enable Port-based Authentication on the switch. By
default, Port-based Authentication is disabled.
Here are the guidelines for enabling Port-based Authentication:
RSTP and MSTP cannot be enabled on authenticator or supplicant
ports.
Authenticator and supplicant ports cannot belong to a trunk group.
Authenticator and supplicant ports cannot be mirror ports.
When Port-based authentication is enabled, authentication using
EAP does not work.
A combo port cannot be an authenticator port.
Confirmation Command
“SHOW PORTAUTH” on page 532
Example
The following command enables Port-Based Authentication on the switch:
Manager > enable portauth
To Next Page
Loading...
