Allied Telesis AT-GS908M User Manual

Chapter 10: HTTP Commands
176 Section II: Switch Management
SET HTTP LISTENPORT
Syntax
set http listenport= port_number
Parameters
port_number
Specifies the TCP port for HTTP. The port number is from 1 to
65535. By default, the TCP port for HTTP is 80.
Description
Use this command to change the TCP port for HTTP.
Confirmation Command
“SHOW HTTP SERVER” on page 177
Example
The following command changes the TCP port for HTTP to 120:
Manager > set http listenport=120

Allied Telesis AT-GS908M Specifications

General

Brand	Allied Telesis
Model	AT-GS908M
Category	Switch
Language	English