AT-GS900M Series CLI Reference
Section II: Switch Management 145
Chapter 8
Simple Network Time Control (SNTP)
Commands
The SNTP commands are summarized in Table 17.
Table 17. SNTP Commands
Command Description
“ADD NTP PEER” on page 146 Changes the IP address of the SNTP
server.
“DELETE NTP PEER” on
page 147
Deletes the SNTP server from the switch.
“DISABLE NTP” on page 148 Disables SNTP.
“DISABLE SUMMER-TIME” on
page 149
Disables Daylight Saving Time.
“ENABLE NTP” on page 150 Enables SNTP.
“ENABLE SUMMER-TIME” on
page 151
Enables Daylight Saving Time.
“PURGE NTP” on page 152 Deletes the settings of SNTP.
“RESET NTP” on page 153 Resets SNTP.
“SET NTP” on page 154 Specifies the IP address of the SNTP
server, UTC offset, the UDP port for
SNTP.
“SET SUMMER-TIME” on
page 157
Specifies the Daylight Saving Time
settings.
“SHOW NTP” on page 158 Displays the SNTP settings and SNTP
counters.
“SHOW SUMMER-TIME” on
page 160
Displays the Daytime Saving Time
settings on the switch.
To Next Page
Loading...
Need help?
General
