EasyManuals Logo

Allied Telesis AT-GS908M User Manual

Allied Telesis AT-GS908M
542 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #269 background imageLoading...
Page #269 background image
AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 269
SHOW SWITCH LOOPDETECTION
Syntax
show switch loopdetection [port=
port_list
|all]
[config|status|counter]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
config
Displays the configurations of Loop Detection.
status
Displays the status of Loop Detection.
counter
Displays the counters of Loop Detection.
Description
Use this command to display information about Loop Detection. An
example of the command output is shown in Figure 37 on page 270.

Table of Contents

Other manuals for Allied Telesis AT-GS908M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AT-GS908M and is the answer not in the manual?

Allied Telesis AT-GS908M Specifications

General IconGeneral
BrandAllied Telesis
ModelAT-GS908M
CategorySwitch
LanguageEnglish

Related product manuals