Chapter 8: Simple Network Time Control (SNTP) Commands
146 Section II: Switch Management
ADD NTP PEER
Syntax
add ntp peer=
ip_address
Parameters
ip_address
Specifies an IPv4 address.
Description
Use this command to configure the IP address of the SNTP server to
synchronize the system time of the switch with the specified SNTP server.
You can specify only one IP address of the SNTP server on the switch.
To synchronize the system time with the SNTP server, you must
enable SNTP. See “ENABLE NTP” on page 150.
Confirmation Command
“SHOW NTP” on page 158
Example
The following command specifies the IP address of the SNTP server:
Manager > add ntp peer=192.168.1.230
To Next Page
Loading...
