AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 231
DISABLE SWITCH LOOPDETECTION
Syntax
disable switch loopdetection port=
port_list
|all
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
Description
Use this command to disable loop protection. By default, loop protection is
disabled.
Confirmation Command
“SHOW SWITCH LOOPDETECTION” on page 269
Example
The following command disables loop protection on port 2:
Manager > disable switch loopdetection port=2
To Next Page
Loading...
