Allied Telesis AT-GS908M - Chapter 19: Power Saving Commands

AT-GS900M Series Command Reference
Section III: Layer 2 Switching 345
Chapter 19
Power Saving Commands
The Power Saving commands are summarized in Table 37.
Table 37. Power Saving Commands
Command Description
“CREATE TRIGGER” on
page 346
Creates a power saving trigger.
“DESTROY TRIGGER” on
page 349
Deletes a power saving trigger.
“DISABLE TRIGGER” on
page 350
Disables a power saving trigger.
“ENABLE TRIGGER” on
page 351
Enables a power saving trigger.
“PURGE TRIGGER” on
page 352
Disables and deletes all power saving
triggers.
“SET LED MODE” on page 353 Specifies the global port LED mode.
“SET LED PORT” on page 354 Specifies the port LED settings on ports.
“SET TRIGGER” on page 356 Modifies a power saving trigger.
“SHOW LED” on page 359 Displays the LED settings.
“SHOW TRIGGER” on page 360 Displays information about triggers.