Allied Telesis AT-GS908M - Show Qos Policy Counter

AT-GS900M Series Command Reference
Section IV: Security and Traffic Control 495
SHOW QOS POLICY COUNTER
Syntax
show qos policy[= policy_list |all] counter
Parameters
port_list
Specifies a list of QoS policies. To specify multiple policies, use a
comma (,) to separate them. To specify a range of policies, use a
hyphen (-).
Description
Use this command to display the counters of the classifiers assigned to the
flow groups that are associated to QoS policy. An example of the
command output is shown in Figure 74.
Figure 74. SHOW QOS POLICY COUNTER Command
Example
The following example displays the counters of the classifiers:
Manager > show qos policy=1 counter
Policy/TrafficClass/FlowGroup Classifier Hit Counter
-------------------------------------------------------------------------
1 Policy 1
1 TrafficClass 1
1 FlowGroup 1 1 Classifier 1 1840569814
2 TrafficClass 2
2 FlowGroup 2 2 Classifier 2 10
3 TrafficClass 3
3 FlowGroup 3 3 Classifier 3 987
4 TrafficClass 4
4 FlowGroup 4 4 Classifier 4 2365490092
5 TrafficClass 5
5 FlowGroup 5 5 Classifier 5 4567
6 TrafficClass 6
6 FlowGroup 6 6 Classifier 6 4554
7 TrafficClass 7
7 FlowGroup 7 7 Classifier 7 15604285020
8 TrafficClass 8
8 FlowGroup 8 8 Classifier 8 23394