Chapter 27: Port-Based Authentication Commands
522 Section IV: Security and Traffic Control
SET PORTAUTH PORT (802.1X Supplicant Port)
Syntax
set portauth[=8021x] port=
port_list
|all type=supplicant
[authperiod=
authperiod
] [heldperiod=
heldperiod
]
[maxstart=
maxstart
] [startperiod=
startperiod
]
[username=
username
] [password=
password
]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
authperiod
Specifies the amount of time in seconds that the 802.1x supplicant
port waits for a response from the authenticator after sending an
EAP-response packet. The range is 1 to 300 seconds. The default
setting is 30 seconds.
heldperiod
Specifies the amount of time in seconds that the 802.1x supplicant
port does not communicate with the authenticator after the
supplicant failed to be authenticated. The range is 0 to 65535
seconds. The default setting is 60 seconds.
maxstart
Specifies how many times the 802.1x supplicant sends an EAPOL
packet before it stops the attempt of being authenticated. The
range is 1 to 10 times. The default setting is 3 times.
startperiod
Specifies the interval in seconds that the 802.1x supplicant port
resends EAPOL-start packets to the authenticator. The range is 1
to 65535 seconds. The default setting is 30 seconds.
username
Specifies the user name of the supplicant. The user name must be
up to 63 alphanumeric characters.
password
Specifies the password of the supplicant. The password must be
up to 63 alphanumeric characters.
To Next Page
Loading...
Need help?
General
