Chapter 25: Quality of Service (QoS) Commands
452 Section IV: Security and Traffic Control
SHOW QOS HWPRIORITY
Syntax
show qos hwpriority
Parameters
None
Description
Use this command to display the QoS priority mapping table on the switch.
An example of the command output is shown in Figure 68.
Figure 68. SHOW QOS HWPRIORITY Command
Example
The following example displays the QoS priority mapping table:
Manager > show qos hwpriority
QoS Priority Mapping
Priority Queue
---------------------
0 1
1 0
2 0
3 1
4 2
5 2
6 3
7 3
---------------------
To Next Page
Loading...
