AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 439
SHOW MLDSNOOPING
Syntax
show mldsnooping
Parameters
None
Description
Use this command to display the settings and status of MLD Snooping. An
example of the command output is shown in Figure 65.
Figure 65. SHOW MLDSNOOPING Command
Example
The following example displays the settings and status of MLD Snooping:
Manager > show mldsnooping
MLD Snooping Configuration:
MLD Snooping Status ................ Enabled
Host/Router Timeout Interval ....... 260 seconds
Maximum MLD Multicast Groups ....... 64 (1)
Router Port(s) ..................... 1-3
IPv6 Multicast Group Address ........ ff05:0:1::101
Multicast MAC Address ............. 33-33-00-00-01-01
Router Port(s) .................... 1
Router List:
VLAN ID Port/TrunkID RouterIP
-----------------------------------------------------------------------
Host List:
Number of MLD Multicast Groups: 0
VLAN Port/ Exp
MulticastGroup ID TrunkID HostIP Time
----------------------------------------------------------------------
To Next Page
Loading...
Need help?
General
