AT-FS900M Series CLI ReferenceAT-GS900M Series CLI Reference
Section III: Layer 2 Switching 375
SHOW STP PORTSTATE
Syntax
show stp portstate[=
port_list
|all]
Parameters
port_list
Specifies one or more ports. To specify multiple ports,
use commas to separate nonconsecutive numbers (for
example 5,7,9) or a dash to specify consecutive
numbers (for example (1-4).
Description
You use this command to display the current operating status of the ports.
An example is shown in Figure 58.
Figure 58. SHOW STP PORTSTATE Command
The columns are described in Table 43.
Port Enable State Role Edge P2P Version Port Cost
---------------------------------------------------------------------
1 Enabled Forwarding Designated No Yes RSTP 200000
2 Enabled Forwarding Designated No Yes RSTP 200000
3 Enabled Forwarding Designated No Yes RSTP 200000
4 Enabled Forwarding Designated No Yes RSTP 200000
5 Enabled Forwarding Designated No Yes RSTP 200000
6 Enabled Forwarding Designated No Yes RSTP 200000
7 Enabled Forwarding Designated No Yes RSTP 200000
8 Enabled Forwarding Designated No Yes RSTP 200000
Table 43. SHOW STP PORTSTATE Command
Column Description
Port The port number.
Enabled Whether STP is enabled or disabled on the
port.
To Next Page
Loading...
Need help?
General
