EasyManuals Logo

Allied Telesis AT-GS908M User Manual

Allied Telesis AT-GS908M
542 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #322 background imageLoading...
Page #322 background image
Chapter 17: DHCP Snooping Commands
322 Section III: Layer 2 Switching
SET DHCPSNOOPING CHECKINTERVAL
Syntax
set dhcpsnooping checkinterval=
time
Parameters
time
Specifies time in seconds. The range is 1 to 3600. The default
value is 60 seconds.
Description
Use this command to change the interval to check the DHCP Snooping
table. The switch checks dynamic entries at the specified intervals and
deletes the dynamic entries that the IP address is expired in.
Confirmation Command
“SHOW DHCPSNOOPING” on page 328
Example
The following command changes the interval to 40 seconds:
Manager > reset dhcpsnooping checkinterval=40

Table of Contents

Other manuals for Allied Telesis AT-GS908M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AT-GS908M and is the answer not in the manual?

Allied Telesis AT-GS908M Specifications

General IconGeneral
BrandAllied Telesis
ModelAT-GS908M
CategorySwitch
LanguageEnglish

Related product manuals