AT-GS900M Series CLI Reference
Section I: Getting Started 57
SHOW INSTALL
Syntax
show install
Parameter
None
Description
Use this command to display the management software information. See
Figure 4 for an example of the command output.
Figure 4. SHOW INSTALL Command
The fields are described in Table 4.
Example
The following command displays the management software information:
manager > show install
Install Release
---------------------------------------------------------
Preferred flash:gs900mv2_v232.rel
----------------------------------------------------------
Current install
----------------------------------------------------------
Preferred flash:gs900mv2_v232.rel
----------------------------------------------------------
Table 4. SHOW INSTALL Command
Field Description
Install Release Displays the name of the software image file that is
selected to run the switch by the SET INSTALL
command. See “SET INSTALL” on page 50.
Current Install Displays the name of the software image file that is
currently running.
To Next Page
Loading...
Need help?
General
