Chapter 14: Switching Commands
250 Section III: Layer 2 Switching
RESET SWITCH PORT
Syntax
reset switch port[=
port_list
|all] [counter]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports. This is the default setting.
counter
Clears only statistics counters without physically resetting the
ports.
Description
Use this command to physically reset a switch port: starting Auto-
negotiation and clearing the statistics counters on the port. With the
keyword counter, the command does not reset the port physically.
Confirmation Command
“SHOW SWITCH PORT” on page 272
Examples
The following command physically resets port 1 to port 10:
Manager > reset switch port=1-10 counter
To Next Page
Loading...
