Chapter 14: Switching Commands
276 Section III: Layer 2 Switching
SHOW SWITCH STORMDETECTION
Syntax
show switch loopdetection [port=
port_list
|all]
[config|status|counter]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
config
Displays the configurations of Storm Detection.
status
Displays the status of Storm Detection.
counter
Displays the counters of Storm Detection.
Description
Use this command to display information about Storm Detection. An
example of the command output is shown in Figure 41 on page 277.
To Next Page
Loading...
