Chapter 20: Rapid Spanning Tree Protocol (RSTP) Commands
364 Section III: Layer 2 Switching
PURGE STP
Syntax
purge stp
Parameters
None
Description
This command returns all the RSTP bridge and port parameters to the
default settings. RSTP must be disabled before you can use this
command. To disable RSTP, refer to “DISABLE STP” on page 362.
Example
The following command resets the RSTP parameters to their default
settings:
purge stp
Equivalent Command
set stp default
For information, refer to “SET STP” on page 365.
To Next Page
Loading...
