AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 241
ENABLE SWITCH LOOPDETECTION
Syntax
enable switch loopdetection port=
port_list
|all
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
Description
Use this command to enable loop protection. By default, loop protection is
disabled on the specified ports.
Confirmation Command
“SHOW SWITCH LOOPDETECTION” on page 269
Example
The following command enables loop protection on port 2:
Manager > enable switch loopdetection port=2
To Next Page
Loading...
