Chapter 11: RADIUS Authentication Server Commands
184 Section II: Switch Management
SET AUTHENTICATION
Syntax
set authentication [timeout=
timeout
] [deadtime=
deadtime
]
[retransmitcount=
retransmitcount
]
[dead-action=deny | permit]
Parameters
timeout
Specifies the maximum amount of time in seconds that the
RADIUS client waits for a response from a RADIUS authentication
server. The range is 1 to15 seconds. The default setting is 6
seconds.
deadtime
Specifies the amount of time in minutes that the RADIUS client
stops communicating with a RADIUS server after the RADIUS
client resent requests to the RADIUS server for the number of
times specified with the retransmitcount parameter. The default
setting is 0 minutes.
retransmitcount
Specifies the maximum number of times that the RADIUS client
resends requests to the same RADIUS server before it sends
requests to next RADIUS server on the list. The default setting is 3
times.
dead-action
Specifies deny or permit communication when a RADIUS server
does not respond. The default setting is deny.
Description
Use this command to specify the settings of RADUS authentication
servers.
Confirmation Command
“SHOW AUTHENTICATION” on page 188
Example
The following command specifies the RADIUS client to wait for a response
from the RADIUS server for 15 seconds:
Manager > set authentication timeout=15
To Next Page
Loading...
Need help?
General
