AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 527
SET PORTAUTH PORT (Canceling the Authentication Type)
Syntax
set portauth port=
port_list
|all type=none
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
Description
Use this command to cancel the port as an authenticator and supplicant.
on the specified port.
Here are references for other usage of this command:
To change the authenticator port settings for all authentication
methods including 802.1x Port-based, MAC address-based, and
Web-based authentication on the specified port, see “SET
PORTAUTH PORT (Authenticator Port for All Methods)” on
page 514.
To change the authenticator port settings for 802.1x Port-based
authentication on the specified port, see “SET PORTAUTH PORT
(802.1X Authenticator Port)” on page 518.
To change the supplicant port settings for 802.1x Port-based
authentication on the specified port, see “SET PORTAUTH PORT
(802.1X Supplicant Port)” on page 522.
To change the authenticator port settings for Web address-based
and Web-based authentication on the specified port, see “SET
PORTAUTH PORT (Authenticator Port for MAC and Web)” on
page 524.
Confirmation Commands
“SHOW PORTAUTH” on page 532
Example
The following command cancels port 1 to 8 as authenticator ports:
Manager > set portauth port=1-8 type=none
To Next Page
Loading...
Need help?
General
