Chapter 25: Quality of Service (QoS) Commands
450 Section IV: Security and Traffic Control
SHOW QOS
Syntax
show qos
Parameters
None
Description
Use this command to display the QoS settings on the switch. An example
of the command output is shown in Figure 66.
Figure 66. SHOW QOS Command
Example
The following example displays information about QoS settings:
Manager > show qos
QoS Information
----------------------------------------------------
Configured State .......... Disabled
Actual State .............. Disabled
Mode ...................... Auto
Scheduling ................ Weighted Round-Robin
----------------------------------------------------
To Next Page
Loading...
