Allied Telesis AT-GS908M - Chapter 23: Internet Group Management Protocol (IGMP) Snooping Commands

AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 417
Chapter 23
Internet Group Management Protocol
(IGMP) Snooping Commands
The IGMP Snooping commands are summarized in Table 48.
Table 48. IGMP Snooping Commands
Command Description
“ADD IGMPSNOOPING
MCGROUP” on page 418
Add a multicast group for IGMP Snooping.
“DELETE IGMPSNOOPING” on
page 421
Deletes a static multicast group address.
“DISABLE IGMPSNOOPING” on
page 422
Disables IGMP Snooping.
“ENABLE IGMPSNOOPING” on
page 423
Enables IGMP Snooping.
“SET IGMPSNOOPING” on
page 424
Specifies the timeout and changes the
settings of the multicast group.
“SET IGMPSNOOPING
MCGROUP” on page 426
Changes the router ports for the multcast
group.
“SHOW IGMPSNOOPING” on
page 427
Displays the settings and status of IGMP
Snooping.