Chapter 14: Switching Commands
266 Section III: Layer 2 Switching
SET SWITCH TRUNK
Syntax
set switch trunk=
trunk_name
speed=1000m|100m|10m
Parameters
trunk_name
Specifies a trunk name.
speed
Specifies port speed.
1000m
The port is set to 1000M speed, the full duplex, and Auto-
negotiation. Combo ports must be set to 1000m. This is the default
setting.
100m
The port is set to 100M speed, the full duplex, and Auto-
negotiation.
10m
The port is set to 10M speed, the full duplex, and Auto-negotiation.
Description
Use this command to change the trunk settings.
Confirmation Command
“SHOW SWITCH TRUNK” on page 278
Example
The following command changes the trunk name to uplink and the speed
to 1000m:
Manager > set switch trunk=uplink speed=1000m
To Next Page
Loading...
