AT-GS900M Series CLI Reference
Section II: Switch Management 165
SET CONSOLE
Syntax
set console [page=
lines
|off|0] [timeout=
timeout
]
[completion=both|tab|space|off]
Parameters
page
Specifies the number of lines to display at a time. When the off
keyword or 0 is specified, the screen shows all lines once.
lines
Specifies the number of lines to display. The range is 4 to 99 lines.
timeout
Specifies time in seconds before the session ends when no
commands are entered. The range is 0 to 3267 seconds. When 0
is specified, the session does not time out.
completion
Specifies the way to expand a partially entered command at the
prompt.
both
Specifies the tab key and space bar to expand a partially entered
command at the prompt. This is the default setting.
tab
Specifies the tab key to expand a partially entered command at the
prompt.
space
Specifies the space bar to expand a partially entered command at
the prompt.
off
Specifies that commands are not expanded at the prompt.
Description
Use this command to specify the number of lines to display, timeout, and
command expansion setting for sessions through Telnet or from the
Console port.
Confirmation Command
“SHOW CONSOLE” on page 169
To Next Page
Loading...
Need help?
General
