Chapter 19: Power Saving Commands
354 Section III: Layer 2 Switching
SET LED PORT
Syntax
set led port=
port_list
|all [action=on|off] [rate=
rate
|none]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
action
Specifies the action of the LINK/ACT LED on a port.
on
The LINK/ACT LED on a port is on.
off
The LINK/ACT LED on a port is on. This is the default setting.
rate
Specifies the threshold of the receiving rate. When the action
parameter is on, this parameter is set to none.
rate
Specifies the threshold in Kbps. The range is 1 to 1024000 Kbps.
When the receiving rate at a port exceeds the threshold, the port
LED flashes.
none
Specifies no threshold. The port LED is off. This is the default
setting.
Description
Use this command to set the port LED settings on ports. The settings are
effective on LINK/ACT LED’s when the global port LED mode is off.
To Next Page
Loading...
Need help?
General
