Allied Telesis AT-GS908M User Manual

AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 415
SHOW ACCESS FILTER
Syntax
show access filter=snmp|ftp|telnet|http|icmp|global|all
Parameters
filter
Specifies an access filter group. See “ADD ACCESS FILTER” on
page 406.
global
Specifies all the access filter groups.
all
Specifies the access filter entries: snmp, ftp, telnet, http, and icmp.
Description
Use this command to display the default action and status of access filter
groups or the settings of the specified access group. An example of the
command output is shown in Figure 62.
Figure 62. SHOW ACCESS FILTER Command
Manager > show access filter
Filter Default Status
------------------------------------------
SNMP Discard Disabled
FTP Pass Disabled
TELNET Discard Disabled
HTTP Pass Disabled
ICMP Pass Disabled
GLOBAL Pass Disabled
------------------------------------------

Allied Telesis AT-GS908M Specifications

General

Brand	Allied Telesis
Model	AT-GS908M
Category	Switch
Language	English