AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 257
SET SWITCH PORT
Syntax
set switch port[=
port_list
|all] [acceptable=all|vlan]
[description=
string
] [mirror=both|none|rx|tx]
[priority=
priority
]
[speed=autonetotiate|10mhalf|10mfull|10mhauto|10mfauto|
100mhafl|100mfull|100mhauto|100mfauto|1000mfull|1000mauto]
[securitymode=automatic|dynamic|limited|secured]
[learn=
max_mac
] [intrusionaction=discard|disable|log|trap]
[combo=fiberauto|copperauto|fiber|copper]
[polarity=mdi|mdix] [bclimit=on|off] [dlclimit=on|off]
[mclimit=on|off]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
acceptable
Specifies the frames that the port can accept.
vlan
Specifies the port to accept VLAN tagged frames. The port
discards the frames in which the VID is 0. The ports that belong to
only a tagged VLAN are always this setting.
all
Specifies the port to accept all frames. The ports that belong to an
untagged VLAN are always this setting.
string
Specifies a port name up to 20 alphanumeric characters including
hash (#), percent (%), question (?), and yen mark (Â¥). To include a
space, place a double quote (“) before and after the space.
mirror
Specifies the traffic type to be mirrored. Pause frames are also
mirrored. You must specify the same traffic type on the switch.
rx
The receiving frames at the port are mirrored.
tx
The transmitting frames at the port are mirrored.
To Next Page
Loading...
Need help?
General
