AT-GS900M Series CLI Reference
Section I: Getting Started 67
Uploading a File from the Switch
You can save files from the switch to the TFTP server or transfer files on
the switch to the FTP client.
Uploading a File
to a TFTP Server
To upload a configuration file on the switch to a TFTP server, use the
UPLOAD command.
The following example uploads the file config3.cfg on the switch to the
TFTP server. The TFTP server has the IP address of 192.168.10.10:
Manager > upload method=TFTP FILE=config3.cfg
server=192.168.10.10
You may fail to upload files onto a TFTP server. You may need to create
files and give write permission for all users before uploading files from the
switch. The following example creates a file, config3.cfg on a TFTP server
and gives write permission to all users:
UNxNOS[1]# cd/tftpboot
UNxNOS[2]# touch config3.cfg
UNxNOS[3]# chmod 666 config3.cfg
Uploading a File
Using FTP
To transfer a configuration file on the switch to the FTP client, perform the
following steps:
1. From the command prompt of the management workstation, type the
following commands. The IP address of FTP server is 192.168.10.5:
C:\> FTP
192.168.10.5
2. Enter the user name at the prompt:
Connected to 192.168.10.5
220 FTP server ready.
User (192.168.10.5:(none)): manager
3. Enter the password at the prompt:
331 Password required for manager
Password: *****
4. After logging in, enter the file transfer GET command at the FTP
prompt:
230 User logged in.
ftp> get config4.cfg
5. Confirm that the file is transfered successfully.
The following is a message example:
To Next Page
Loading...
Need help?
General
