AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 377
Chapter 21
Multiple Spanning Tree Protocol
(MSTP) Commands
The MSTP commands are summarized in Table 44 and described in this
chapter.
Table 44. Multiple Spanning Tree Protocol Commands
Command Description
“ADD MSTP MSTI VLAN” on
page 379
Associates VLANS to MST instances.
“CREATE MSTP MSTI” on
page 380
Creates an MST instance.
“DELETE MSTP MSTI VLAN” on
page 381
Releases a VLAN from the associated MST
instance.
“DESTROY MSTP MSTI” on
page 382
Deletes an MST instance.
“DISABLE MSTP” on page 383 Disables MSTP on the selected ports or the
switch.
“DISABLE MSTP DEBUG MSTI”
on page 384
Disables the debug option on an MST
instance.
“ENABLE MSTP” on page 385 Enables MSTP on the selected ports or the
switch.
“ENABLE MSTP DEBUG MSTI”
on page 387
Enables the debug option on an MST
instance.
“PURGE MSTP” on page 389 Sets all the MSTP parameters to the default
settings.
“RESET MSTP COUNTER
PORT” on page 390
Clears MSTP counters on the specified port.
“SET MSTP” on page 391 Specifies the MSTP settings of the switch.
“SET MSTP CIST” on page 393 Specifies the bridge priority for Common and
Internal Spanning Tree (CIST).
“SET MSTP CIST PORT” on
page 394
Specifies the MSTP settings for CIST.
To Next Page
Loading...
Need help?
General
