AT-GS900M Series CLI Reference
Section I: Getting Started 37
Chapter 3
Basic CLI Management Commands
The basic Command Line Interface (CLI) management commands are
summarized in Table 2.
Table 2. Basic CLI Management Commands
Command Description
“BYE” on page 39 Ends the current management session.
“CLS” on page 40 Clears the screen.
“DISABLE SYSTEM FAN-
STARTSTOP-ALARM” on
page 41
Disables sending alarm messages when
the fan starts or stops.
“ENABLE SYSTEM FAN-
STARTSTOP-ALARM” on
page 42
Enables sending alarm messages when the
fan starts or stops.
“EXIT” on page 43 Ends the current management session.
“HELP” on page 44 Displays help information.
“LOGOFF” on page 46 Ends the current management session.
“LOGOUT” on page 47 Ends the current management session.
“QUIT” on page 48 Ends the current management session.
“RESTART” on page 49 Resets the hardware components of the
switch and restart the switch
“SET INSTALL” on page 50 Specifies a configuration file as the boot
configuration file.
“SET PASSWORD” on page 51 Changes the login password.
“SET SYSTEM” on page 52 Sets values for the sysName, sysLocation,
and sysContact MIB objects.
“SET SYSTEM SFP-
TEMPTHRESHOLD” on page 53
Sets the temperature threshold for SFP
modules. When the temperature exceeds
this value, the switch sends alarm
messages.
“SET TIME” on page 54 Sets the system time and date.
“SHOW CPU” on page 55 Displays the CPU usage of the switch.
To Next Page
Loading...
Need help?
General
