Allied Telesis AT-GS908M User Manual

Chapter 25: Quality of Service (QoS) Commands
446 Section IV: Security and Traffic Control
SET QOS HWPRIORITY
Syntax
set qos hwpriority queue= p0 , p1 , p2 , p3 , p4 , p5 , p6 , p7
Parameters
queue
Specifies a list of the values of DiffServ Code Point (DSCP). To
specify multiple values, use a comma (,) to separate them. To
specify a range of values, use a hyphen (-).
p0 , p1 , p2 , p3 , p4 , p5 , p6 , p7
Specifies queue numbers for the user priorities, 0 to 7. Queue
numbers are 0 to 3. The highest priority queue is 3. See Table 53
for the default settings.
Description
Use this command to change the QoS priority map.
The default settings of the QoS priority map is shown in Table 53.
Confirmation Command
“SHOW QOS HWPRIORITY” on page 452
Table 53. Default QoS Priority Map
Priority Queue Number
01
10
20
31
42
52
63
73

Allied Telesis AT-GS908M Specifications

General

Brand	Allied Telesis
Model	AT-GS908M
Category	Switch
Language	English