Allied Telesis AT-GS908M User Manual

AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 249
RESET SWITCH LOOPDETECTION COUNTER
Syntax
reset switch loopdetection [port= port_list |all] counter
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports. This is the default setting.
Description
Use this command to clear the counters of the loop detection feature on
the specified ports.
Confirmation Command
“SHOW SWITCH LOOPDETECTION” on page 269
Example
The following command clears the counters of the loop detection feature
on port 2:
Manager > reset switch loopdetection port=2 counter

Allied Telesis AT-GS908M Specifications

General

Brand	Allied Telesis
Model	AT-GS908M
Category	Switch
Language	English