Allied Telesis AT-GS908M User Manual

Chapter 17: DHCP Snooping Commands
332 Section III: Layer 2 Switching
SHOW DHCPSNOOPING PORT
Syntax
show dhcpsnooping port[= port_list |all]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
Description
Use this command to display the settings of DHCP Snooping for the
specified port. An example of the command output is shown in Figure 51.
Figure 51. SHOW DHCPSNOOPING PORT Command
Example
The following example displays the settings of DHCP Snooping on port 1:
Manager > show dhcpsnooping port=1
DHCP Snooping Port Information:
----------------------------------------------------------
Port ..................... 11
Trusted .................. No
Full Leases/Max Leases ... 1/1
Subscriber-ID ............ None
----------------------------------------------------------

Allied Telesis AT-GS908M Specifications

General

Brand	Allied Telesis
Model	AT-GS908M
Category	Switch
Language	English