Allied Telesis AT-GS908M User Manual

Chapter 24: Multicast Listener Discovery (MLD) Snooping Commands
434 Section IV: Security and Traffic Control
ENABLE MLDSNOOPING
Syntax
enable mldsnooping
Parameters
None
Description
Use this command to enable Multicast Listener Discovery (MLD)
Snooping on the switch. The switch supports MLD versions 1 and 2
Snooping. By default, MLD Snooping is disabled.
When MLD Snooping is disabled, the switch forwards IPv6 multicast traffic
to all ports belong to the same VLAN if any of the ports is a member of the
multicast group. When MLD Snooping is enabled, the switch snoops MLD
messages and forwards IPv6 multcast traffic only to multicast member
ports.
Note
The switch does not support the source filtering function of MLD
version 2 Snooping.
Confirmation Command
“SHOW MLDSNOOPING” on page 439
Example
The following command enables MLD Snooping:
Manager > enable mldsnooping

Allied Telesis AT-GS908M Specifications

General

Brand	Allied Telesis
Model	AT-GS908M
Category	Switch
Language	English