Allied Telesis AT-GS908M User Manual

AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 245
ENABLE SWITCH PORT FLOW
Syntax
enable switch port= port_list |all flow
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
Description
Use this command to enable flow control on switch ports. By default, flow
control is enabled. When flow control is enabled, the ports accept PAUSE
frames, but does not send PAUSE frames.
To enable flow control on a trunk port, you must specify all trunk ports in
the trunk group.
Confirmation Command
“SHOW SWITCH” on page 267
Example
The following command enables flow control on port 3:
Manager > enable switch port=3 flow

Allied Telesis AT-GS908M Specifications

General

Brand	Allied Telesis
Model	AT-GS908M
Category	Switch
Language	English