Chapter 11: RADIUS Authentication Server Commands
188 Section II: Switch Management
SHOW AUTHENTICATION
Syntax
show authentication
Parameters
None
Description
Use this command to display a list of RADIUS servers and their settings.
An example of the command output is shown in Figure 30.
Figure 30. SHOW AUTHENTICATION Command
The fields are described in Table 25.
RADIUS Server Parameters
-------------------------------------------------------------------------------
Server Retransmit Count..... 3
Server Timeout.............. 6 sec
Server Dead Time............ 0 min
Server Dead Action.......... Deny
-------------------------------------------------------------------------------
RADIUS Servers:
Server IP Address Auth Port Encryption Key Auth Req Auth Resp Status
-------------------------------------------------------------------------------
0.0.0.0 1812 <Not Defined> 0 0 Alive
0.0.0.0 1812 <Not Defined> 0 0 Alive
-------------------------------------------------------------------------------
Table 25. SHOW AUTHENTICATION Command
Field Description
Server Retransmit
Count
Displays the maximum number of times that the
RADIUS client resends requests to the same
RADIUS server before it sends requests to next
RADIUS server on the list.
Server Timeout Displays the maximum amount time in seconds
that the RADIUS client waits for a response from
a RADIUS server.