Chapter 6: Log Commands
110 Section II: Switch Management
SHOW LOG STATUS
Syntax
show log status
Parameters
None
Description
Use this command to display the log status:
An example of the command output is shown in Figure 16.
Figure 16. SHOW LOG STATUS Command
Example
The following command displays the log status:
Manager> show log status
Log System Status
--------------------------------------------
Log Module Status .............. Enabled
Log Message Generation ......... Enabled
Permanent Output ............... Enabled
Syslog Output .................. Disabled
Next Message ID ................ 3008
Number of Output Definitions ... 2
--------------------------------------------
To Next Page
Loading...
