Allied Telesis AT-GS908M User Manual

Chapter 23: Internet Group Management Protocol (IGMP) Snooping Commands
426 Section IV: Security and Traffic Control
SET IGMPSNOOPING MCGROUP
Syntax
set igmpsnooping mcgroup= ip_address
routerport=
port_list |all
Parameters
mcgroup
Specifies an IP multicast group address.
routerport
Specifies ports for router ports.
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
ip_address
Specifies an IPv4 address.
all
Specifies all the switch ports.
Description
Use this command to change the router ports for multicast groups. You
can change the router ports only for the multicast groups added statically
by the ADD IGMPSNOOPING MCGROUP command.
Confirmation Command
“SHOW IGMPSNOOPING” on page 427
Example
The following command changes the router ports for the multicast group
224.1.1.1:
Manager > set igmpsnooping mcgroup=224.1.1.1 routerport=1

Allied Telesis AT-GS908M Specifications

General

Brand	Allied Telesis
Model	AT-GS908M
Category	Switch
Language	English