Chapter 3: Basic CLI Management Commands
42 Section I: Getting Started
ENABLE SYSTEM FAN-STARTSTOP-ALARM
Syntax
enable system fan-startstop-alarm
Parameters
None
Description
Use this command to send alarm messages when the fan starts and
stops. Alarm messages are:
SNMP trap
Syslog message
Log message
Event message
By default, when the fan starts and stops, the switch sends alarm
messages.
Confirmation Command
“SHOW SYSTEM” on page 58
Example
The following example enables the fan and alarm messages:
manager > enable system fan-startstop-alarm
To Next Page
Loading...
