AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 401
SHOW MSTP COUNTER PORT
Syntax
show mstp counter port[=
port_list
|all]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
Description
Use this command to display the MST counters on the specified ports. See
Figure 60 for an example.
Figure 60. SHOW MSTP COUNTER PORT Command
Examples
The following command displays the MSTP counters of port 5:
show mstp counter port=5
MSTP Port Counters
-----------------------------------------------------------
Port Number 5
Receive: Transmit:
Total BPDUs 581 Total BPDUs 579
MSTP BPDUs 581 MSTP BPDUs 579
RSTP BPDUs 0 RSTP BPDUs 0
STP BPDUs 0 STP BPDUs 0
Invalid BPDUs 0
Discarded:
Port Disabled 0
Invalid Protocol 0
Invalid Type 0
Invalid BPDU length 0
-----------------------------------------------------------
To Next Page
Loading...
Need help?
General
